1988 JEEP CHEROKEE 2DR SUV
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition YEL (+) IGNITION SWITCH HARNESS
Starter01 DK.GRN (+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/WHT (-) (-) AT UNDER DASH LIGHT
TrunkTrigger N/A WORKS WITH DOME LIGHT
HoodTrigger N/A
FactoryAlarmDisarm N/A
ParkingLights BLU (+) (+) LIGHT SWITCH HARNESS
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition YEL (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BRN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 DK.GRN (+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach GRN (-) (-) AT COIL
SpeedSense WHT/ORG (AC) HARNESS FROM TRANSMISSION
ParkingLights BLU (+) (+) LIGHT SWITCH HARNESS
BrakeLights WHT (+) AT BRAKE SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock DK.GRN (REV) W/KEYLESS LT.GRN TAN PASS KICK POS TRI
PowerLock WHT (REV) DRIVER'S KICK PANEL REVERSE POLARITY
LeftFrontWindow01 LF-LTBLU
RightFrontWindow01 RF-BRN/WHT
LeftRearWindow01 LF-WHT
RightRearWindow01 RF-VIO/WHT
Doorlocks / Windows
Power UnLock
TAN (+) WITH KEYLESS
PowerLock
LIGHT GREEN (+) WITH KEYLESS
Convenience
TrunkRelease BLK/WHT NAUAL RELEASE
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 BRN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination ORG/BLK (+) RADIO HARNESS
Dimmer DK.BLU/WHT (+) RADIO HARNESS
PowerAntenna GRY (+) RADIO HARNESS
FrontLeftSpeakerPos GRN
FrontLeftSpeakerNeg BLK/YEL
FrontRightSpeakerPos WHT
FrontRightSpeakerNeg BLACK
RearLeftSpeakerPos GRY/WHT
RearLeftSpeakerNeg BRN/WHT
RearRightSpeakerPos WHT/BLK
RearRightSpeakerNeg BRN
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
